BIQU Hurakan DIY FDM 3D Printer

Product Showcase

BTT Manta M4P+CB1

The latest main control board and core board, Manta M4P and CB1, enables Hurakan to run Klipper and also supports Marlin.

Klipper is Ready

Klipper, a huge leap in 3D printer firmware, has been pre-installed on Hurakan. So you don't have to deal with complicated installationprocedures but enjoy speed, precision, and convenience.

Enjoy Wireless Printing

Thanks to the built-in WiFi module, it is easier for users to print pause, check the printing progress, and adjust the temperatureof the nozzle on different terminal platforms(The control device and printer must be connected to the same WiFi network).

BIQU MicroProbe

The self-developed auto leveling sensor, mini-sized, 6g super lightweight, can use more than 10 million times, will add almost no weight to the extruder but offershigh precision leveling capability.

Quiet 3D Printing

Thanks to the TMC2209, an ultra-silent motor driver IC, the printingnoise can be significantly reduced.

Choose the Part to Heat

Switch the hotbed use area to adjust the hotbed power, which is more energy-saving and environmentally friendly. ●100W---for the central part of the bed (red light on) ●240W---for the whole bed (both blue and red lights on)

Filament Runout Sensor

With the filament runout sensor, the printer will automatically pause a print if filaments run out or break, saving time and filaments.

Light up Your Prints

A beautifully designed, fully customizable RGB light illuminates. Your prints in the dark, giving you full 16.8M color control via the web interface or the display screen.

Get Start Quickly

Thanks to the modular design, assembling the printer is fast and fun.

01 - Dual USB Ports A USB flash drive can be used to print without an Internet connection, a USB plug and play camera can be connected for wireless monitoring.

02 - Power Supply Optional Suitable for different voltages of 100-120V/200-240V.

03 - RJ45 Port Offer a choice of a more reliable wired network connection. *Note: This is a Gigabit Ethernet port.Currently, the CB1 installed on Hurakan only supports 100M Ethernet. If you want to experience Gigabit Ethernel, you can replace CB1 with CM4.

04 - SPI Interface Designed for connecting an ADXL 345 accelerometer to realize Klipper's Resonance Compensation for a higher precision print.

Dimensions & Specs

Packaging List

Note: Above are schematic diagrams of products, accessoriesuser interfaces, etc., for reference only. Please refer to the actual product because product updates may make the actual product slightly different from the schematic diagram.